Project & Case
Contact Us
- Address: Guangjian Building, No.12 – Wangcheng Road, Luoyang, China
- Zip Code:
- Email:
- Phone:
- Fax:
FAQ
-
2023-11-16What are the causes and solutions for excessive vibration of the large blow…
Vibration can occur when the motor of the tempering blower and the coupling of its reducer are not concentric. In this case, we should check the concentricity of the coupling, and reinstall or replace the coupling.
-
2023-10-17What should you consider when setting the heating time for a glass tempe…
The heating time of the glass tempering furnace should be adjusted according to actual conditions.
-
2023-09-19How should we address the quality issues with bent tempered glass?
When there are discrepancies in the curvature settings of the bending chillers in the glass tempering furnace, it can cause the bent tempered glass to have inaccurate curvature.
-
2023-08-18What causes the white haze in the center of tempered glass during the gla…
If the tempered glass oscillates too quickly inside the glass tempering furnace, white haze may occur.
-
2023-07-19How does one operate the emergency stop in a glass tempering furnace?
The main operating station of the glass tempering furnace and the control boxes for the critical components are each equipped with emergency stop buttons. Should an emergency arise, the operator can instantly halt all driving operations of the glass
-
2023-06-20Maintaining the Air Compressor for Glass Tempering Furnace
In the field of glass tempering process, the air compressor supplying compressed air to the glass tempering furnace is very important.
-
2023-05-24How to measure the local bow and the edge kink of tempered glass?
How to measure the local bow and the edge kink of tempered glass? Measure the gap between the glass and the ruler with a feeler gauge. The maximum value is the local bow of the glass.
-
2023-04-30What should I pay attention to when tempering different types of glass in…
When tempering glass with holes and slots, the heating time should be increased by 2.5% to 5% compared to glass of the same size without holes and slots